#KENWOOD NX 3320 PROGRAMMING SOFTWARE FULL#
#KENWOOD NX 3320 PROGRAMMING SOFTWARE PC#

Most radios use the microphone jack as the programming port, but some have a separate data port for programming and/or PC to internal TNC interface. Please check this listingвЂ™s photos for a close-up of the connector to ensure that this cable matches the physical characteristics of your radioвЂ™s port before ordering this cable. If you do not see your radio model in my store and you see I sell the cable you think you need, contact me. Let me know about any listing errors and/or omissions so I can correct them for the greater good. Please excuse the mistakes I will make during the reorganization. This is a very large task that will take years. In addition, this will enable me to communicate what I know about the operating systems that are required to successfully program your radio before you buy my cable.

#KENWOOD NX 3320 PROGRAMMING SOFTWARE FULL#

If you are not happy with my cables, I will give you a full refund.My goal is to organize all my eBay cable listings by factory programming software title and provide an internet link to the software for those who need it. I worked as a computer support engineer for 15 years before starting this business.

You get my personal email, cell phone number and my promise that I will do my very best to support you. I provide excellent installation instructions with every cable. I am not your typical eBay seller, so please take a moment and read on to understand my message to you.

This is my passion! My cables work! I now have more than 120 radios, costing more than $20K used just for testing my cables with programming software. With the cable you get my installation instructions, email address and cell phone number. This listing is for a single true USB Programming cable compatible only with the new generation of Kenwood two-way radios that use the KPG-22 dual-pin connector Be advised that Kenwood charges $155 for their KPG-D3N software for these radios and you can only run it one MAC address!! Also, you must purchase the software from a Kenwood dealer and the dealer may add their own service charges to send you the software.

Kenwood nx-3320 programming software